“…we don’t make mistakes here, we just have happy accidents.” ― Bob Ross
A plurality of “happy accidents” indeed.
The first happy accident: the head badge slipped from my fingers. The paint was irreparably damaged. One of the edges was now deformed.
Oh, dear. It was one of those days and all I could do was sigh, take a breath, and reflect. Although I liked how the orange-painted head badge looked by itself, it blended in too much with the paint, so I took advantage of this “happy” accident.
The second happy accident was not happy at all. Nor was it an accident. It was definitely a mistake: I placed the water bottle bosses on the seat tube too low. The cages clear each other just fine. But, putting bottles in the cages will have one or the other bottle sitting on top of the other. Nothing that couldn’t be addressed in one of four ways: 1) don’t use a second water bottle cage; 2) use the water bottle bosses on the seat tube for something else; 3) adapt a water bottle cage to fit slightly higher, either on the down tube or the seat tube; or, 4) fix it with a little bit of fire magic and a lot of time and elbow grease.
When Life Gives You Gold…
Once more into the film canister filled with acetone, the head badge was stripped of its paint. Before I could paint it again, the damaged edge had to be repaired. Using the scalpel to scrape and some sandpaper to smooth, the damaged edge was repaired.
And once more, the head badge was cleaned, degreased, and primed. This time, I painted the entire head badge gloss black and gave it a heavy clear-coat.
One day later…
With a scalpel and a sharpened bamboo stick, I removed the clear-coat, paint, and primer from the gold-anodized raised lettering and emblem. I liked the effect more than all of my other attempts at finishing the head badge; more like the original, but without the gold edge. It did get one more coat of clear to seal everything.
I waited two days before applying the self-adhesive pad. This time, I was very careful to keep hold of the head badge…success!

I Have a Drinking Problem
Owning my water bottle boss placement mistake, and all that led to it, was self-evident and already accepted. The brief, gut-wrenching horror of my own blunder was not pleasant, but it did afford the opportunity to reflect on my established build processes and, in this case, understanding the reason for not adhering to them.
Sometimes, negative reinforcement is needed to instill a lesson. The lesson here being: be present, don’t rush, give your full attention to the task at hand, whatever it may be.
If only I were as good at building frames as I am at washing dishes…there is still a long way to go before I am at that level of proficiency and perfection. Of course, I’ve been washing dishes for more than fifty years, so there is still hope and time to improve with regard to metalworking. In the mean time, I will have to make do with one water bottle cage: I’ll have to drink less or re-fill more often.
What better way to stew reflect on my mistake than to put together my “new” 1984 Koga-Miyata Luxe?
Assembly Day
More accurately, it was three days of assembly, including learning to wrap the handlebars with leather using a cross-stitched seam.
The first day was just facing, chasing, reaming, and placing the seatpost and frame bearings.
I managed to take some photos at the end of the day:

Postscript
Do you need or want a beautiful custom bicycle or replica? Do you have a treasured bicycle that needs repair, alteration, renovation, or restoration? Well, you can contact this perfectionist frame builder to do the work well and with great care.

























